1, if the system requirement of axial not lengthen, for installation of the sensor can be used intelligent coupling, can detect the torque, and can undertake the function of the coupling. Also is a kind of coupling with detection.

2, the transmission system to be tested are not allowed to lengthen but can be removed, you can use a suit - set on the measured shaft torque sensor can be test.

3, the transmission system to be tested, both are not allowed to lengthen and not can be removed, you can use the assembly at the scene of card type torque sensor. From both sides of the shaft in the shaft can be tested. Can be long-term monitoring can also be short-term test. Similar to current clip-on table.

4, some test system when there are both torque and axial force you can use the torque speed axial force three parameters of the sensor; Can avoid the axial force of the torsion test signal interference and axial force can be measured;

5, under the high speed or super-high speed tests can use without bearing type torque speed sensor;

6, if the system under test is not rotating state can use a torque sensor and transmitter;

7, if the system under test in 5 mn m. to maximum 1 n m. can use small range torque speed sensor

8, intelligent torque speed measuring instrument

More convenient to use the series of torque sensor, cooperate to design the intelligent torque speed measuring instrument and computer virtual instruments, the two instruments can directly show the measuring torque and rotational speed, the power value of numerical and curve, can also set the torque limit value, value alarm, also can save the peak and the torque curve of the measurement, and can print out the above parameters and graphs.